HOW TO...
Top Coil Tanks

HOW TO FILL WITH E-LIQUID

1. Unscrew the mouthpiece (drip tip) from the top of the tank being careful not to lose the rubber o-ring.

 
2. Looking down into the tank you will see a small hole in the center, DO NOT put liquid in this hole.
 
3. Holding the bottle in such a way that the e-liquid can run down the side of the tank, begin to fill slowly. Do not allow the liquid to pool on top as it will flow into the center of the coil.
 
4. Fill to maximum fill line indicated on the side of the tank and screw the mouthpiece back in place.

HOW TO REPLACE THE COIL

1. Unscrew the body of the tank from the base and carefully separate (if your tank has / had e-liquid in it this will be a bit messy, so be prepared).

 
2. Grasp the coil and unscrew from the center post. Discard.
 
3. Screw a new coil assembly onto the center post, replace the tank on the base and firmly tighten by hand. Allow the tank to sit for a few minutes for the juice to soak into the wicking material before vaping.

TIPS & TRICKS

All top coil tanks suffer from the occasional "dry hit". This is caused because the wicks cannot always carry enough e-liquid to the coil to be vaporized, especially if the tank has been standing upright for a long period of time, or during heavy use. By holding the e-cigarette horizontal and gently rolling your hand over, this can be avoided. This may be more necessary as the fluid level gets lower in the tank
(especially half and below).
 
 
Bottom Coil Tanks
 
HOW TO FILL WITH E-LIQUID
 
1. Turn the tank upside down and unscrew the base from the tank. While the tank is inverted, a few drops of liquid condensation may leak out of the mouthpiece so be prepared.
 
2. Looking down into the tank you will see a small hole in the center, DO NOT put liquid in this hole.
 
3. Holding the bottle in such a way that the e-liquid can run down the side of the tank, begin to fill slowly. Watch either from the side, or the top to monitor fill level. Fill to the top of the center post without going into the hole. If you over fill, the e-liquid will run out the mouthpiece like a sink drain!
 
4. Replace the base and screw on firmly by hand.

HOW TO REPLACE THE COIL

1. Turn the tank upside down and unscrew the base from the tank. While the tank is inverted, a few drops of liquid condensation may leak out of the mouthpiece so be prepared.
 
2. Grasp the coil and unscrew from the base. Discard. This is also a good time to clean off any excess e-liquid that might be on the base.
 
3. Screw a new coil into the base firmly by hand. Reassemble the tank. Before you fire the coil it needs to be primed. Draw on the mouthpiece as if you were inhaling (WITHOUT pushing the fire button). Do this until you can start to taste the flavor in the air (you are not trying to suck liquid into your mouth). Once this is accomplished let the tank sit for a few minutes and try a light draw with the fire button. If it still tastes dry repeat. DO NOT skip priming a bottom coil. This will greatly affect the overall life of the coil and your vaping experience.

TIPS & TRICKS

Bottom coil tanks are by far the most readily available and commonly used in the current market. Other than priming the coils the next best piece of advice is do not overtighten! The coil should be firmly screwed into the base, and the base should be “finger tight snug” to the upper assembly. In almost no circumstance will cranking the tank together with pliers fix any problem you may be having. When you remove the base, if the coil remains in the chimney, you are doing something wrong. 
 
Batteries
 
This section used to be easy, back when there was only a few in the market. Now there are dozens if not hundreds of different systems and it would be nearly impossible to give detailed instructions for all of them. We certainly are very knowledgeable with what we sell, and at least mostly able to run other batteries. Below are some of the most common problems we see on a daily basis.
 
  • Turn your battery on. Most of the time when people come in for “it doesn’t work” the battery was just turned off.

 

  • Know the functions of your battery. How to adjust the power setting. What the different color lights mean. What the numbers on the display indicate. By taking the time to familiarize yourself with your setup you may avoid problems with a simple adjustment.

 

  • Make sure your battery / tank combination is making the best use of both. By pairing hardware together correctly you can maximize your vaping experience. Do a little research or come in and let us blow your socks off with a perfect setup tailored to how YOU  like to vape.